Skip to main content
Empire Telecom

Call quality

Check your connection for calls.

Thirty seconds that behave like a phone call, then download and upload. You get a score, what it means, and a one-tap way to send it to us.

–Call quality

Run it from a wired computer on the same network as the phones. It takes about a minute.

Packet loss

–%

Jitter

–ms

Response time

–ms

Download

–Mbps

Upload

–Mbps

Calls at once

–estimate

  • Your public IPChecking…
  • ProviderChecking…
  • NearChecking…

Measured against Cloudflare’s nearest server. A browser can only estimate packet loss; your firewall shows the exact figure. Nothing is stored.

What the numbers mean

Four things a call needs.

  • Packet loss under 1%

    Lost packets are lost pieces of speech. Above 1% calls cut in and out.

  • Jitter under 30 ms

    Jitter is uneven timing. A little is smoothed over; a lot sounds choppy or robotic.

  • Response time under 150 ms

    Above that, people start talking over each other.

  • About 100 kbps per call, each way

    Small, but it has to get through even when everyone else is streaming.

Choppy calls

It is almost always the building network.

When calls break up, the phones and the phone system are rarely the cause. The usual suspects are below, and every one of them shows up in this check or on the firewall.

  • The internet line is maxed out, often by guest Wi-Fi and streaming
  • The line itself is losing packets, which only the carrier can repair
  • Calls are not given priority over everything else
  • Phones on Wi-Fi, or behind a cheap desk switch
  • Equipment left behind by the previous phone provider

For your IT team

The network checklist for EmpireUC.

Send this section to whoever looks after your network. The full requirements are in our help center.

  • Phones on their own voice network

    A voice VLAN for phones and paging devices. Yealink phones join it by themselves through LLDP; devices that cannot, like paging adapters, need a port set for voice or their own VLAN tag.

  • Voice gets priority

    Prioritize voice traffic on the firewall and switches, and set the firewall to the line’s real speed so the priority can work when the line is full.

  • No SIP helpers

    Turn off SIP ALG or SIP inspection on the firewall. It rewrites calls and breaks audio.

  • Paging stays local

    Phone-to-phone paging is multicast on the local network. Phones and overhead paging adapters must be on the same VLAN, and switches must not filter or rate-limit that multicast.

  • Retire the old system

    Routers, adapters and DHCP servers from the previous provider can hand out the wrong addresses. Remove them once EmpireUC is live.

  • The full requirements

    Addresses, ports and settings are in Voice network details, in our help center.

Reporting a call problem

What to send us.

Run the check from the building, at the time the trouble happens, and send us the results with these.

  • The results, from the Email them to support button above
  • The facility, the room, and wired or Wi-Fi
  • Which phones, and roughly when the bad calls were
  • A number you called or that called you, if you have one